APRS Track Direct

My position About ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790653176	483 Count	224 Count	105 Count
1790651495	453 Count	211 Count	97 Count
1790649814	411 Count	190 Count	82 Count
1790641659	298 Count	141 Count	61 Count
1790639978	276 Count	132 Count	58 Count
1790638297	257 Count	124 Count	55 Count
1790636616	235 Count	114 Count	51 Count
1790633263	154 Count	76 Count	25 Count
1790631574	119 Count	59 Count	14 Count
1790629893	97 Count	44 Count	10 Count
1790628212	81 Count	37 Count	9 Count
1790626532	58 Count	30 Count	7 Count
1790625133	43 Count	22 Count	5 Count
1790623452	27 Count	14 Count	3 Count
1790621771	12 Count	7 Count	1 Count
1790620091	1014 Count	496 Count	206 Count
1790618410	999 Count	488 Count	204 Count
1790615297	966 Count	474 Count	200 Count
1790613617	949 Count	466 Count	198 Count
1790611936	928 Count	457 Count	194 Count
1790610255	897 Count	441 Count	184 Count
1790608574	847 Count	419 Count	167 Count
1790606894	806 Count	400 Count	154 Count
1790605213	765 Count	371 Count	139 Count
1790603532	728 Count	352 Count	125 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)