APRS Track Direct

My position About ☰

reset

SP8SOB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1778051345	658 Count	602 Count	493 Count
1778050424	655 Count	600 Count	491 Count
1778049508	652 Count	598 Count	489 Count
1778048600	647 Count	591 Count	485 Count
1778047700	645 Count	590 Count	484 Count
1778046799	642 Count	588 Count	482 Count
1778045898	636 Count	583 Count	477 Count
1778044997	633 Count	581 Count	475 Count
1778044097	629 Count	577 Count	472 Count
1778043196	625 Count	573 Count	469 Count
1778042295	621 Count	569 Count	466 Count
1778041394	617 Count	565 Count	463 Count
1778040494	613 Count	559 Count	460 Count
1778039593	609 Count	553 Count	457 Count
1778038693	603 Count	545 Count	452 Count
1778037802	600 Count	541 Count	450 Count
1778036897	597 Count	538 Count	448 Count
1778035974	593 Count	532 Count	445 Count
1778026510	592 Count	532 Count	445 Count
1778025589	588 Count	529 Count	442 Count
1778024667	585 Count	527 Count	440 Count
1778023757	581 Count	523 Count	437 Count
1778022856	577 Count	519 Count	434 Count
1778021955	571 Count	511 Count	429 Count
1778021054	567 Count	506 Count	426 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)