APRS Track Direct

My position About ☰

reset

F1ZZM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZZM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Rx ed*	Dig ed*	Decode*
1790657346	71 Packet	14 Packet	64 %
1790653686	75 Packet	13 Packet	72 %
1790650026	69 Packet	10 Packet	65 %
1790646367	66 Packet	13 Packet	68 %
1790642706	61 Packet	12 Packet	65 %
1790639046	60 Packet	11 Packet	68 %
1790635386	59 Packet	9 Packet	66 %
1790631726	48 Packet	14 Packet	47 %
1790628067	46 Packet	13 Packet	48 %
1790620746	39 Packet	10 Packet	44 %
1790617086	30 Packet	5 Packet	44 %
1790613426	35 Packet	6 Packet	44 %
1790609767	39 Packet	13 Packet	50 %
1790606106	42 Packet	7 Packet	55 %
1790598787	31 Packet	5 Packet	48 %
1790595127	42 Packet	8 Packet	55 %
1790591467	45 Packet	7 Packet	50 %
1790587807	45 Packet	8 Packet	54 %
1790584147	39 Packet	6 Packet	43 %
1790580487	44 Packet	6 Packet	46 %
1790576827	60 Packet	11 Packet	51 %
1790573167	51 Packet	8 Packet	49 %

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx ed: 0, 1, 0

Dig ed: 0, 1, 0

Decode: 0, 1, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)