APRS Track Direct

My position About ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1770126050	530 Count	792 Count	366 Count
1770124250	521 Count	782 Count	358 Count
1770122449	518 Count	778 Count	356 Count
1770120648	515 Count	774 Count	354 Count
1770118855	508 Count	766 Count	352 Count
1770117055	505 Count	758 Count	350 Count
1770115254	502 Count	754 Count	348 Count
1770113453	496 Count	746 Count	343 Count
1770111652	493 Count	741 Count	341 Count
1770109852	490 Count	737 Count	339 Count
1770108051	487 Count	732 Count	337 Count
1770106250	484 Count	728 Count	335 Count
1770104449	481 Count	724 Count	333 Count
1770102649	478 Count	721 Count	331 Count
1770100848	475 Count	716 Count	329 Count
1770099047	472 Count	711 Count	327 Count
1770097254	463 Count	697 Count	323 Count
1770095453	457 Count	688 Count	318 Count
1770093653	452 Count	682 Count	314 Count
1770091852	445 Count	673 Count	308 Count
1770090051	440 Count	665 Count	304 Count
1770088251	435 Count	656 Count	300 Count
1770086450	430 Count	647 Count	296 Count
1770084649	425 Count	639 Count	292 Count
1770082848	420 Count	631 Count	288 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)