APRS Track Direct

My position About ☰

reset

BU2GE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BU2GE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	CPUTemp*	DiGi*
1786720137	33.9 C	751 p
1786718936	33.8 C	741 p
1786717736	34.3 C	731 p
1786716536	34.4 C	715 p
1786715336	34.3 C	705 p
1786714137	34.9 C	696 p
1786712936	35.4 C	685 p
1786711737	34.6 C	672 p
1786710537	35 C	650 p
1786709337	34 C	631 p
1786708136	34.8 C	621 p
1786706937	34.6 C	612 p
1786705737	34.2 C	584 p
1786704536	34.6 C	570 p
1786703337	35.2 C	563 p
1786702136	34.8 C	523 p
1786700936	34.2 C	513 p
1786699736	34.2 C	503 p
1786698537	34.9 C	488 p
1786697337	34.6 C	478 p
1786696136	34.9 C	467 p
1786694936	33.8 C	457 p
1786693737	34.6 C	449 p
1786692537	34.9 C	440 p
1786691339	34.2 C	430 p

*Used Equation Coefficients:

CPUTemp: 0, 1, 0

RxPkts/20m: 0, 1, 0

RxPkts/1h: 0, 1, 0

RxPkts/24h: 0, 1, 0

DiGi: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)