APRS Track Direct

My position About ☰

reset

DL1LMH-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1LMH-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	VBat*	Temp*
1790648012	4.1 V	23.18 degC
1790647952	3.82 V	23.18 degC
1790647892	3.72 V	23.18 degC
1790647832	4.17 V	24.12 degC
1790647772	3.7 V	23.18 degC
1790647712	3.72 V	24.12 degC
1790647652	3.71 V	23.18 degC
1790647592	3.72 V	24.12 degC
1790647532	4.31 V	24.12 degC
1790647472	3.75 V	24.12 degC
1790647412	3.75 V	24.12 degC
1790647352	3.72 V	24.12 degC
1790647292	3.98 V	24.12 degC
1790647232	4.48 V	24.12 degC
1790647172	3.75 V	24.12 degC
1790647112	3.72 V	24.12 degC
1790647052	3.7 V	24.12 degC
1790646992	3.89 V	24.12 degC
1790646932	3.85 V	24.12 degC
1790646872	3.73 V	24.12 degC
1790646812	4.41 V	24.12 degC
1790646752	3.73 V	24.12 degC
1790646692	4.48 V	24.12 degC
1790646632	3.73 V	24.12 degC
1790646572	3.71 V	24.12 degC

*Used Equation Coefficients:

VBat: 0, 0.007843, 2.5

Temp: 0, 0.470588, -30

CH3: 0, 0, 0

CH4: 0, 0, 0

CH5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)