APRS Track Direct

My position About ☰

reset

YM6KTK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YM6KTK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1786740990	-81 dBm	0.21 V
1786740248	-80 dBm	0.21 V
1786739506	-82 dBm	0.18 V
1786738833	-81 dBm	0.21 V
1786738003	-82 dBm	0.21 V
1786737261	-76 dBm	0.18 V
1786736519	-81 dBm	0.18 V
1786735574	-78 dBm	0.18 V
1786734826	-76 dBm	0.18 V
1786734086	-76 dBm	0.18 V
1786733342	-81 dBm	0.21 V
1786732606	-78 dBm	0.21 V
1786731858	-82 dBm	0.21 V
1786731116	-79 dBm	0.18 V
1786730374	-77 dBm	0.18 V
1786729632	-77 dBm	0.18 V
1786728890	-81 dBm	0.18 V
1786728148	-79 dBm	0.21 V
1786727406	-79 dBm	0.18 V
1786726664	-75 dBm	0.18 V
1786725922	-75 dBm	0.21 V
1786725182	-79 dBm	0.41 V
1786724438	-80 dBm	1.15 V
1786723696	-81 dBm	1.89 V
1786722954	-76 dBm	2.24 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)