APRS Track Direct

My position About ☰

reset

WB6ETY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770085829	1372	735	359	730	38
1770085110	1369	736	365	730	33
1770084789	1365	735	365	730	33
1770084390	1371	736	365	730	33
1770083669	1372	736	365	730	37
1770082989	1384	735	359	730	32
1770082950	1372	735	359	730	34
1770082230	1377	735	365	730	33
1770081510	1372	734	365	730	36
1770081189	1372	733	359	725	32
1770080789	1372	733	354	730	42
1770080070	1374	732	365	725	33
1770079389	1372	731	365	725	32
1770079349	1372	731	354	725	35
1770078630	1372	731	359	725	33
1770077591	1372	728	359	720	37
1770076471	1371	726	354	720	35
1770075789	1372	725	354	716	33
1770075030	1375	724	354	716	33
1770074310	1377	723	354	716	34
1770073989	1372	723	354	716	33
1770073590	1372	722	354	716	34
1770072869	1384	721	354	716	33
1770072189	1377	719	349	712	34
1770072150	1372	719	354	716	39

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)