APRS Track Direct

My position About ☰

reset

SQ8PDY-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774087926	70 Count	196 Count	62 Count
1774086126	52 Count	142 Count	45 Count
1774084325	21 Count	72 Count	15 Count
1774082525	8 Count	35 Count	3 Count
1774080724	4 Count	0 Count	0 Count
1774078929	173 Count	973 Count	153 Count
1774077129	165 Count	915 Count	146 Count
1774075328	153 Count	870 Count	135 Count
1774073528	145 Count	823 Count	128 Count
1774071727	133 Count	763 Count	117 Count
1774069927	122 Count	703 Count	107 Count
1774068126	114 Count	656 Count	100 Count
1774066325	107 Count	599 Count	94 Count
1774062724	83 Count	472 Count	72 Count
1774060923	72 Count	409 Count	62 Count
1774059123	64 Count	343 Count	55 Count
1774057328	49 Count	282 Count	45 Count
1774055528	41 Count	228 Count	38 Count
1774051926	22 Count	119 Count	21 Count
1774050126	10 Count	60 Count	10 Count
1774048325	185 Count	1084 Count	168 Count
1774046525	157 Count	998 Count	141 Count
1774044724	144 Count	903 Count	129 Count
1774042923	128 Count	841 Count	114 Count
1774041123	122 Count	782 Count	109 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)