APRS Track Direct

My position About ☰

reset

KF4BWT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF4BWT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*
1732265525	100	48	2	128
1732264625	100	48	2	128
1732263724	100	48	2	128
1732262824	100	48	2	128
1732261924	100	48	2	128
1732261024	100	48	2	128
1732260124	100	48	2	128
1732259224	100	48	2	128
1732258324	100	48	2	128
1732257424	100	48	2	128
1732256523	100	48	2	128
1732255623	100	48	2	128
1732254723	100	48	2	128
1732253823	100	48	2	128
1732252923	100	48	2	128
1732252023	100	48	2	128
1732251123	100	48	2	128
1732250223	100	48	2	128
1732249323	100	48	2	128
1732248422	100	48	2	128
1732247522	100	48	2	128
1732246622	100	48	2	128
1732245722	100	48	2	128
1732244822	100	48	2	128
1732243922	100	48	2	128

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)