APRS Track Direct

My position About ☰

reset

IDIOTV Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IDIOTV. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786726444	171	190	87	46	76
1786724046	172	190	88	47	77
1786721647	176	195	88	47	76
1786719247	171	190	88	47	70
1786716846	168	186	86	46	76
1786714444	167	185	86	46	76
1786712043	167	186	86	46	76
1786709645	167	186	86	46	76
1786707245	167	186	86	46	77
1786704843	167	186	86	46	76
1786702446	168	186	86	46	76
1786700044	168	186	86	46	76
1786697644	168	187	86	46	76
1786695246	168	187	87	46	76
1786692845	168	187	86	46	76
1786690443	169	187	86	46	75
1786688046	169	187	87	46	76
1786685644	169	187	87	46	75
1786683244	169	187	87	46	75
1786680846	169	187	87	46	76
1786678445	170	188	87	46	77
1786676044	170	189	87	46	77
1786673644	172	191	88	47	77
1786671244	174	192	87	46	78
1786668845	171	189	87	47	78

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)