APRS Track Direct

My position About ☰

reset

VE1NWC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE1NWC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value4*	Value5*
1786718293	550	570	533	115
1786717085	541	552	523	115
1786715876	541	550	522	115
1786714070	537	544	519	114
1786712870	531	539	514	114
1786710461	530	538	513	114
1786709255	528	534	509	113
1786708654	528	533	509	113
1786706241	527	531	508	113
1786703830	522	526	504	112
1786702621	520	524	504	112
1786701416	519	523	501	112
1786700214	522	526	504	113
1786699011	523	506	505	112
1786697804	524	506	506	112
1786696601	487	488	485	100
1786694792	524	508	508	112
1786693582	525	509	507	113
1786692376	526	509	508	112
1786688166	526	510	509	113
1786687564	528	509	508	112
1786686357	527	510	510	113
1786685151	526	510	510	112
1786684552	527	511	509	112
1786683347	526	509	509	112

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)