APRS Track Direct

My position About ☰

reset

VE7OKN-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE7OKN-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1766084937	131	130	0	31	134
1766082536	130	130	0	31	133
1766069336	129	130	0	31	134
1766059736	130	129	0	31	134
1766057336	130	130	0	31	133
1766056136	130	130	0	31	133
1766042936	130	130	0	31	134
1766041736	130	130	0	31	133
1766035735	130	130	0	31	131
1766034535	130	130	0	31	130
1766032135	130	130	0	31	130
1766029735	130	130	0	31	128
1766028535	131	130	0	31	128
1766024934	131	130	0	31	128
1766022535	131	130	0	31	131
1766018934	132	131	0	31	128
1766017735	132	131	0	31	129
1766016534	132	131	0	31	130
1766015334	133	131	0	31	131
1766011734	134	133	0	31	133
1766010534	134	133	0	31	133
1766009334	135	133	1	32	133
1766004534	135	133	0	31	133
1766003334	133	132	0	31	133

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)