APRS Track Direct

My position About ☰

reset

ZL2PO-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL2PO-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790653177	135	127	255	63	47
1790651976	136	127	255	62	46
1790650775	136	127	255	62	46
1790649574	136	126	255	63	47
1790648373	136	125	255	63	47
1790647172	136	125	255	64	48
1790645971	136	125	255	64	48
1790644770	136	124	255	64	48
1790643569	136	124	255	65	49
1790642368	137	123	255	65	49
1790641167	137	123	255	65	49
1790639966	137	122	255	65	50
1790638765	137	122	255	66	51
1790637564	138	121	255	66	51
1790636363	141	121	255	66	51
1790635162	143	121	255	67	51
1790633961	143	119	255	67	52
1790632760	143	118	255	68	53
1790632101	133	108	255	75	60
1790631559	143	117	255	69	54
1790630358	142	115	255	70	55
1790629157	137	112	255	72	57
1790627956	134	111	255	73	58
1790626755	133	110	255	74	59
1790625554	133	108	255	75	60

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)