APRS Track Direct

My position About ☰

reset

YC1IVW-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC1IVW-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	RSSI*	Voltage*
1768283938	-72 dBm	10.38 V
1768283098	-73 dBm	10.36 V
1768281109	-75 dBm	10.36 V
1768279288	-72 dBm	10.36 V
1768277392	-70 dBm	10.29 V
1768275843	-73 dBm	10.29 V
1768273672	-72 dBm	10.36 V
1768271851	-72 dBm	10.34 V
1768269953	-72 dBm	10.29 V
1768268131	-69 dBm	10.29 V
1768266230	-72 dBm	10.38 V
1768264408	-73 dBm	10.34 V
1768262445	-73 dBm	10.29 V
1768260623	-70 dBm	10.29 V
1768259457	-71 dBm	10.34 V
1768257556	-71 dBm	10.34 V
1768255734	-68 dBm	10.29 V
1768253839	-69 dBm	10.34 V
1768252017	-70 dBm	10.34 V
1768250120	-71 dBm	10.29 V
1768248298	-70 dBm	10.29 V
1768246402	-71 dBm	10.29 V
1768244580	-71 dBm	10.34 V
1768242685	-71 dBm	10.34 V
1768240861	-70 dBm	10.34 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)