APRS Track Direct

My position About ☰

reset

K5NOT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object K5NOT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750232443	131	87	129	107	91
1750228847	131	88	128	105	91
1750225252	131	89	129	106	90
1750221657	131	89	129	105	89
1750218061	131	91	128	105	89
1750214465	131	92	127	104	88
1750210870	131	93	130	105	89
1750207274	131	95	128	104	87
1750203677	131	95	128	105	88
1750200081	131	95	127	104	87
1750196485	131	94	128	105	88
1750192890	131	93	128	104	89
1750189295	131	92	128	104	89
1750185700	131	91	129	105	90
1750182104	131	89	128	105	89
1750178507	131	88	128	105	90
1750174912	131	86	129	106	92
1750171316	131	84	129	107	92
1750164125	131	82	130	107	93
1750156935	131	83	129	107	92
1750153336	131	85	129	107	91

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)