APRS Track Direct

My position About ☰

reset

VK4JRO-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK4JRO-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1778052571	123	255	230	228	227
1778050695	122	255	229	227	226
1778048864	116	255	229	226	225
1778047046	122	255	228	225	224
1778043445	123	255	226	223	222
1778038041	127	255	224	221	220
1778036241	127	255	223	220	219
1778034440	127	255	223	220	218
1778030817	127	255	222	219	217
1778028938	135	255	222	218	217
1778027137	135	255	221	218	217
1778025336	124	255	221	218	216
1778023536	123	255	221	218	216
1778021735	123	255	221	217	216
1778019932	123	255	221	217	216
1778018131	123	255	221	217	216
1778016329	123	255	220	217	215
1778014527	117	255	220	217	215
1778012700	123	255	220	217	215
1778010899	123	255	220	216	215
1778009098	123	255	220	216	215
1778007297	123	255	220	216	215
1778005496	123	255	220	216	214
1778003694	123	255	219	216	214
1778001894	122	255	219	216	214

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)