APRS Track Direct

My position About ☰

reset

KD6DCN-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KD6DCN-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value3*	Value4*	Value5*
1782537694	117	116	40	82
1782536794	117	116	43	81
1782535894	115	114	40	81
1782534994	117	116	40	82
1782534095	118	116	39	82
1782533193	118	116	40	81
1782532293	119	117	40	82
1782531393	118	117	39	82
1782530493	116	115	40	82
1782529593	117	116	40	82
1782528693	119	118	43	82
1782527792	118	117	42	82
1782526894	118	116	43	79
1782525993	117	116	43	79
1782525092	118	117	41	79
1782524192	119	118	42	80
1782523292	119	117	43	79
1782522392	120	118	48	78
1782521491	120	119	44	75
1782520596	120	119	50	75
1782519691	120	119	41	75
1782518791	121	119	41	74
1782517897	120	118	43	80
1782516993	121	119	40	80
1782516092	119	117	42	79

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)