APRS Track Direct

My position About ☰

reset

VA7OGO-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VA7OGO-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786737459	136	29	59	63	49
1786731983	136	24	61	41	48
1786730154	136	30	61	41	48
1786728311	136	30	63	41	48
1786726485	136	25	65	41	48
1786724663	136	24	65	41	48
1786722828	136	25	67	41	48
1786721007	140	30	66	66	49
1786719182	141	33	69	65	49
1786713706	127	29	70	41	48
1786711873	126	28	70	41	49
1786710028	126	29	69	41	48
1786708183	126	25	68	41	48
1786706340	126	27	70	41	48
1786702663	126	28	68	41	48
1786700831	126	27	68	41	48
1786699013	126	25	68	41	49
1786697192	126	68	100	42	48
1786695368	126	26	70	66	49
1786693544	126	22	64	40	48
1786691722	126	27	64	41	48
1786689894	127	27	70	41	49
1786688061	127	26	96	42	74
1786686224	127	23	70	66	49
1786684392	127	27	66	67	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)