APRS Track Direct

My position About ☰

reset

SR9NLI Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9NLI. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx10min*	Vbatt*
1786731342	92 Pkt	12.76 V
1786730713	92 Pkt	12.76 V
1786730098	112 Pkt	12.78 V
1786729482	91 Pkt	12.78 V
1786728868	86 Pkt	12.78 V
1786727638	95 Pkt	12.78 V
1786727019	95 Pkt	12.8 V
1786726403	113 Pkt	12.74 V
1786725788	96 Pkt	12.74 V
1786725173	84 Pkt	12.76 V
1786723942	80 Pkt	12.78 V
1786723324	80 Pkt	12.78 V
1786722708	92 Pkt	12.8 V
1786722092	91 Pkt	12.78 V
1786721464	93 Pkt	12.74 V
1786720233	81 Pkt	12.76 V
1786719000	101 Pkt	12.76 V
1786718384	90 Pkt	12.76 V
1786717770	99 Pkt	12.8 V
1786717155	99 Pkt	12.78 V
1786716539	81 Pkt	12.76 V
1786715921	133 Pkt	12.8 V
1786714690	105 Pkt	12.8 V
1786712843	106 Pkt	12.8 V
1786712224	83 Pkt	12.78 V

*Used Equation Coefficients:

Rx10min: 0, 1, 0

Visc10min: 0, 1, 0

Digi10min: 0, 1, 0

Vbatt: 0, 0.02, 10

Tempre: 0, 0.5, -50

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)