APRS Track Direct

My position About ☰

reset

4K6EH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6EH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1779832012	350 Count	977 Count	13 Count
1779831109	349 Count	976 Count	13 Count
1779830205	348 Count	976 Count	13 Count
1779829302	347 Count	976 Count	13 Count
1779828398	346 Count	976 Count	13 Count
1779827495	345 Count	976 Count	13 Count
1779826591	344 Count	976 Count	13 Count
1779825688	343 Count	976 Count	13 Count
1779824784	342 Count	975 Count	13 Count
1779823881	341 Count	975 Count	13 Count
1779822978	339 Count	974 Count	12 Count
1779822074	337 Count	973 Count	11 Count
1779821171	336 Count	973 Count	11 Count
1779820267	335 Count	973 Count	11 Count
1779819364	334 Count	973 Count	11 Count
1779818460	333 Count	973 Count	11 Count
1779817557	332 Count	973 Count	11 Count
1779816653	331 Count	973 Count	11 Count
1779815750	330 Count	973 Count	11 Count
1779814929	329 Count	973 Count	11 Count
1779814025	328 Count	973 Count	11 Count
1779813122	327 Count	973 Count	11 Count
1779812219	326 Count	973 Count	11 Count
1779811315	325 Count	973 Count	11 Count
1779810412	324 Count	973 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)