APRS Track Direct

My position About ☰

reset

SQ9IWE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IWE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786726422	99 Count	430 Count	97 Count
1786724621	73 Count	293 Count	72 Count
1786722820	36 Count	149 Count	36 Count
1786721020	210 Count	1009 Count	205 Count
1786719219	181 Count	895 Count	177 Count
1786717418	152 Count	720 Count	149 Count
1786715617	126 Count	561 Count	124 Count
1786713817	72 Count	310 Count	71 Count
1786712016	38 Count	142 Count	38 Count
1786710215	179 Count	1091 Count	168 Count
1786708414	155 Count	936 Count	145 Count
1786706613	130 Count	811 Count	121 Count
1786704813	113 Count	678 Count	106 Count
1786703052	90 Count	498 Count	87 Count
1786701251	59 Count	353 Count	57 Count
1786699450	39 Count	235 Count	38 Count
1786697650	17 Count	109 Count	17 Count
1786695849	177 Count	1059 Count	167 Count
1786694048	156 Count	920 Count	147 Count
1786692247	131 Count	734 Count	123 Count
1786690447	108 Count	600 Count	101 Count
1786688646	88 Count	464 Count	82 Count
1786686845	65 Count	331 Count	60 Count
1786685044	42 Count	218 Count	41 Count
1786683244	22 Count	115 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)