APRS Track Direct

My position About ☰

reset

VE6AMC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6AMC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786739339	118	195	150	68	45
1786738439	117	196	150	68	45
1786737539	117	193	150	68	45
1786736645	117	195	150	68	43
1786735739	117	193	150	68	44
1786734839	118	195	150	68	45
1786733939	118	200	150	68	45
1786733044	117	196	150	68	43
1786732139	118	197	150	68	45
1786731239	117	197	150	68	45
1786730339	117	194	150	68	45
1786729445	119	199	150	68	43
1786728538	119	200	150	68	45
1786727638	117	197	150	68	45
1786726738	112	196	150	68	45
1786725845	113	194	149	68	43
1786724938	111	191	149	68	44
1786724038	113	191	149	68	45
1786723138	113	192	149	68	45
1786722244	112	192	149	68	43
1786721338	112	190	149	68	45
1786720438	111	188	149	68	45
1786719538	112	190	149	68	45
1786718645	112	190	149	68	43
1786717738	113	192	149	68	45

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)