APRS Track Direct

My position About ☰

reset

F4MLV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1768258064	105 Count	143 Count	56 Count
1768257719	101 Count	141 Count	54 Count
1768255918	91 Count	140 Count	53 Count
1768255804	87 Count	137 Count	50 Count
1768255083	74 Count	94 Count	41 Count
1768250188	8 Count	0 Count	0 Count
1768250053	7 Count	0 Count	0 Count
1768248764	1 Count	0 Count	0 Count
1768247840	509 Count	981 Count	366 Count
1768246037	479 Count	893 Count	345 Count
1768244233	447 Count	803 Count	321 Count
1768242429	411 Count	711 Count	292 Count
1768216849	410 Count	711 Count	292 Count
1768215046	364 Count	632 Count	253 Count
1768213242	341 Count	599 Count	237 Count
1768211438	319 Count	574 Count	222 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)