APRS Track Direct

My position About ☰

reset

SP6DJA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6DJA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1764178623	526 Count	651 Count	96 Count
1764178616	525 Count	650 Count	96 Count
1764178582	524 Count	649 Count	96 Count
1764178401	522 Count	647 Count	95 Count
1764178220	521 Count	645 Count	95 Count
1764178040	520 Count	644 Count	95 Count
1764177859	519 Count	642 Count	95 Count
1764177678	518 Count	640 Count	95 Count
1764177497	516 Count	638 Count	94 Count
1764177317	515 Count	636 Count	94 Count
1764177136	514 Count	635 Count	94 Count
1764176955	513 Count	633 Count	94 Count
1764176775	512 Count	631 Count	94 Count
1764176685	510 Count	629 Count	93 Count
1764176504	509 Count	628 Count	93 Count
1764176323	508 Count	626 Count	93 Count
1764176143	507 Count	625 Count	93 Count
1764175962	506 Count	622 Count	93 Count
1764175781	504 Count	620 Count	92 Count
1764175600	503 Count	620 Count	92 Count
1764175419	502 Count	618 Count	92 Count
1764175239	501 Count	617 Count	92 Count
1764175058	500 Count	614 Count	92 Count
1764174877	498 Count	612 Count	91 Count
1764174696	497 Count	611 Count	91 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)