APRS Track Direct

My position About ☰

reset

KQ6DI Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	CPU*	PC Board*	Tc*	count*	dBm*
1790653803	40.8	739	550	567	38
1790653204	40.8	739	549	567	38
1790652603	40.8	739	548	566	38
1790652004	40.8	739	548	566	37
1790651403	40.8	738	546	564	37
1790650803	40.8	737	542	561	38
1790650203	40.2	737	540	560	38
1790649603	39.7	731	535	552	38
1790649004	39.2	727	537	550	37
1790648403	40.8	744	583	588	38
1790647804	40.8	742	582	586	37
1790647203	40.8	743	584	587	36
1790646603	40.8	743	582	586	37
1790646004	40.8	742	572	581	37
1790645403	41.3	741	562	575	38
1790644804	40.8	741	561	574	37
1790644203	40.8	739	560	572	38
1790643614	40.8	739	559	571	37
1790643004	40.8	738	558	570	38
1790642403	40.2	736	556	567	37
1790641804	40.8	735	555	566	37
1790641203	39.7	734	553	564	37
1790640604	40.8	732	551	561	37
1790640003	40.2	729	550	558	34
1790639403	38.6	721	555	552	35

*Used Equation Coefficients:

CPU: 0, 0.1, 0

PC Board: 0, 1, 0

Tc: 0, 1, 0

count: 0, 1, 0

dBm: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)