APRS Track Direct

My position About ☰

reset

KQ6DI-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786730403	402	710	699	644	574
1786729504	397	707	698	646	574
1786728604	397	704	696	658	576
1786727704	397	700	691	668	576
1786726803	392	697	688	670	574
1786725904	392	694	688	670	574
1786725004	397	691	686	670	572
1786724104	392	690	686	678	575
1786723203	386	688	683	676	572
1786722303	392	689	684	673	571
1786721404	392	689	684	671	571
1786720504	397	687	684	673	571
1786719603	392	688	684	670	570
1786718704	392	689	685	671	571
1786717804	397	690	685	666	570
1786716904	392	689	685	670	571
1786716003	392	688	686	660	567
1786715104	386	689	689	648	565
1786714202	397	691	691	631	560
1786713304	397	701	699	616	561
1786712403	392	702	700	614	561
1786711504	408	704	700	612	561
1786710604	402	705	702	609	560
1786709704	397	706	705	603	560
1786708803	397	707	707	601	561

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)