APRS Track Direct

My position About ☰

reset

MB7VZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7VZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Mains*	Battery*
1770184225	14.11 V	13.61 V
1770182423	14.11 V	13.61 V
1770180621	14.11 V	13.61 V
1770178819	14.11 V	13.61 V
1770177018	14.11 V	13.61 V
1770175216	14.11 V	13.61 V
1770171612	14.11 V	13.61 V
1770168008	14.11 V	13.61 V
1770164405	14.11 V	13.61 V
1770148189	14.11 V	13.61 V
1770146387	14.11 V	13.61 V
1770144586	14.11 V	13.61 V
1770142784	14.11 V	13.61 V
1770140982	14.11 V	13.61 V
1770139180	14.11 V	13.61 V
1770135577	14.11 V	13.61 V
1770133775	14.11 V	13.61 V
1770131973	14.11 V	13.61 V
1770130171	14.11 V	13.61 V
1770126568	14.11 V	13.61 V
1770124766	14.11 V	13.61 V
1770122965	14.11 V	13.61 V
1770121163	14.11 V	13.61 V
1770113956	14.11 V	13.61 V
1770112154	14.11 V	13.61 V

*Used Equation Coefficients:

Mains: 0, 0.0993382, 0

Battery: 0, 0.0986131, 0

PktRcd: 0, 1, 0

Temp: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)