APRS Track Direct

My position About ☰

reset

ED5YAS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ED5YAS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790634043	116	126	24	149	128
1790633862	116	125	36	149	128
1790633682	116	126	31	149	128
1790633501	116	126	42	150	127
1790633320	116	126	37	149	128
1790633140	116	125	39	149	127
1790632959	116	125	33	149	127
1790632779	116	126	30	149	128
1790632598	116	125	35	149	128
1790632417	116	126	26	149	128
1790632237	116	125	31	149	128
1790632056	116	125	29	149	127
1790631875	116	125	40	149	128
1790631695	116	126	36	150	128
1790631514	116	126	31	150	128
1790631334	116	126	40	150	128
1790631153	116	125	36	150	127
1790630973	116	125	30	150	127
1790630792	116	126	35	149	128
1790630611	117	125	38	150	128
1790630431	116	126	29	149	255
1790630250	116	126	24	149	127
1790630070	116	127	44	149	127
1790629889	116	126	39	149	127
1790629708	116	126	36	149	128

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)