APRS Track Direct

My position About ☰

reset

ALDER Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ALDER. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274653	201	44	31	23	119
1836274501	201	45	31	23	119
1836274350	201	44	31	23	119
1836274200	201	45	31	24	119
1836274050	201	45	31	24	119
1782506215	219	40	29	22	116
1782505914	216	39	29	23	118
1782505614	211	39	29	23	118
1782505314	216	39	28	22	118
1782505014	214	38	28	22	118
1782504414	218	39	28	22	118
1782504114	221	39	29	22	118
1782503814	222	39	29	23	118
1782503516	231	40	29	23	118
1782503215	212	41	30	23	118
1782502915	215	41	30	23	118
1782502614	213	40	29	23	118
1782502314	213	42	30	23	118
1782502014	214	42	30	23	116
1782501714	214	42	30	23	118
1782501415	214	43	30	23	118
1782501114	212	43	30	23	118
1782500815	213	43	30	23	118
1782500515	213	42	30	23	118
1782500214	214	41	30	23	118

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)