APRS Track Direct

My position About ☰

reset

SQ5CZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5CZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790649013	251 Count	356 Count	166 Count
1790648111	248 Count	350 Count	164 Count
1790647210	245 Count	344 Count	162 Count
1790646309	242 Count	340 Count	160 Count
1790645407	239 Count	333 Count	158 Count
1790644506	236 Count	327 Count	156 Count
1790643614	232 Count	321 Count	154 Count
1790642704	229 Count	316 Count	152 Count
1790641802	226 Count	310 Count	150 Count
1790640901	223 Count	305 Count	148 Count
1790640000	220 Count	298 Count	146 Count
1790639099	217 Count	294 Count	144 Count
1790638227	214 Count	290 Count	142 Count
1790637326	211 Count	284 Count	140 Count
1790636425	208 Count	279 Count	138 Count
1790635524	205 Count	272 Count	136 Count
1790634622	202 Count	267 Count	134 Count
1790633721	199 Count	261 Count	132 Count
1790632820	196 Count	256 Count	130 Count
1790631918	193 Count	251 Count	128 Count
1790631017	190 Count	246 Count	126 Count
1790630116	187 Count	242 Count	124 Count
1790629215	184 Count	237 Count	122 Count
1790628313	181 Count	233 Count	120 Count
1790627412	178 Count	228 Count	118 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)