APRS Track Direct

My position About ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770137141	53 Count	179 Count	52 Count
1770135340	30 Count	100 Count	30 Count
1770133540	434 Count	1091 Count	422 Count
1770131739	394 Count	987 Count	383 Count
1770129938	368 Count	907 Count	358 Count
1770128138	336 Count	829 Count	327 Count
1770126337	310 Count	756 Count	302 Count
1770124536	270 Count	669 Count	263 Count
1770122736	230 Count	591 Count	224 Count
1770120935	175 Count	478 Count	170 Count
1770119134	144 Count	376 Count	140 Count
1770117334	110 Count	293 Count	107 Count
1770115533	84 Count	219 Count	82 Count
1770113732	58 Count	155 Count	57 Count
1770111932	27 Count	76 Count	27 Count
1770110131	440 Count	1015 Count	420 Count
1770108331	409 Count	937 Count	390 Count
1770106530	381 Count	869 Count	363 Count
1770104729	344 Count	778 Count	327 Count
1770102929	306 Count	682 Count	290 Count
1770102293	301 Count	680 Count	290 Count
1770101176	296 Count	678 Count	290 Count
1770099374	257 Count	590 Count	252 Count
1770097574	193 Count	449 Count	189 Count
1770095773	149 Count	360 Count	146 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)