APRS Track Direct

My position About ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1770399497	221 Count	442 Count
1770398894	220 Count	442 Count
1770398290	219 Count	440 Count
1770397687	218 Count	440 Count
1770397083	217 Count	439 Count
1770396476	216 Count	435 Count
1770395996	215 Count	434 Count
1770395393	214 Count	431 Count
1770394789	213 Count	429 Count
1770394186	212 Count	427 Count
1770393582	211 Count	425 Count
1770392979	210 Count	424 Count
1770392376	209 Count	424 Count
1770391772	208 Count	421 Count
1770391169	207 Count	420 Count
1770390565	206 Count	418 Count
1770389966	205 Count	416 Count
1770389362	204 Count	415 Count
1770387548	201 Count	412 Count
1770386944	200 Count	410 Count
1770386341	199 Count	407 Count
1770385738	198 Count	405 Count
1770385133	197 Count	403 Count
1770384530	196 Count	400 Count
1770383927	195 Count	398 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)