APRS Track Direct

My position About ☰

reset

SP5XTF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5XTF-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786729489	493 Count	420 Count	98 Count
1786728588	492 Count	420 Count	98 Count
1786727687	491 Count	420 Count	98 Count
1786726787	490 Count	420 Count	98 Count
1786725886	489 Count	420 Count	98 Count
1786724985	488 Count	420 Count	98 Count
1786724084	487 Count	420 Count	98 Count
1786723184	486 Count	420 Count	98 Count
1786722299	485 Count	420 Count	98 Count
1786721398	477 Count	413 Count	91 Count
1786720497	476 Count	413 Count	91 Count
1786719597	475 Count	413 Count	91 Count
1786718696	472 Count	411 Count	89 Count
1786717795	468 Count	408 Count	86 Count
1786716895	467 Count	408 Count	86 Count
1786715994	466 Count	408 Count	86 Count
1786715093	465 Count	408 Count	86 Count
1786714193	464 Count	408 Count	86 Count
1786713292	463 Count	408 Count	86 Count
1786712391	462 Count	408 Count	86 Count
1786711490	461 Count	408 Count	86 Count
1786710590	460 Count	408 Count	86 Count
1786709689	459 Count	408 Count	86 Count
1786708788	458 Count	408 Count	86 Count
1786707888	457 Count	408 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)