APRS Track Direct

My position About ☰

reset

3Z2T-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 3Z2T-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value4*	Value5*
1758181463	114	626	410	218
1758179663	112	620	410	218
1758177863	110	588	409	218
1758176064	108	576	409	218
1758174265	106	568	408	218
1758172464	104	561	408	219
1758170666	102	545	408	187
1758168867	100	536	408	62
1758167066	98	526	408	50
1758165266	96	517	408	50
1758163467	94	507	408	50
1758161669	92	493	408	50
1758159870	90	484	408	50
1758158069	88	471	408	50
1758156269	86	462	408	50
1758154469	84	454	409	50
1758152669	82	447	409	50
1758150869	80	440	409	50
1758149071	78	435	409	50
1758147272	76	429	409	50
1758145471	74	423	409	50
1758143672	72	415	409	50
1758141872	70	409	409	50
1758140074	68	401	409	50
1758138274	66	395	410	50

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)