APRS Track Direct

My position About ☰

reset

SP7TWA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TWA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1790680658	408 Count	842 Count
1790679757	407 Count	841 Count
1790678856	406 Count	839 Count
1790677955	405 Count	838 Count
1790677054	404 Count	836 Count
1790676154	403 Count	835 Count
1790675253	402 Count	833 Count
1790674352	401 Count	832 Count
1790673451	400 Count	830 Count
1790672550	399 Count	828 Count
1790671650	398 Count	826 Count
1790670749	397 Count	825 Count
1790669848	396 Count	823 Count
1790668947	395 Count	822 Count
1790668046	394 Count	820 Count
1790667145	393 Count	819 Count
1790666245	392 Count	817 Count
1790665344	391 Count	815 Count
1790664443	390 Count	811 Count
1790663542	389 Count	808 Count
1790662641	388 Count	805 Count
1790661741	387 Count	803 Count
1790660840	386 Count	799 Count
1790659939	385 Count	793 Count
1790659059	384 Count	785 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)