APRS Track Direct

My position About ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762298739	43 Count	88 Count	39 Count
1762296938	32 Count	77 Count	29 Count
1762295137	21 Count	65 Count	19 Count
1762293337	11 Count	40 Count	10 Count
1762291536	225 Count	1017 Count	185 Count
1762289735	213 Count	982 Count	174 Count
1762287935	200 Count	943 Count	162 Count
1762286134	186 Count	899 Count	150 Count
1762284333	175 Count	882 Count	140 Count
1762282532	163 Count	855 Count	130 Count
1762280732	151 Count	807 Count	119 Count
1762278939	141 Count	777 Count	110 Count
1762277138	129 Count	731 Count	99 Count
1762275338	111 Count	663 Count	82 Count
1762273537	98 Count	610 Count	70 Count
1762271736	96 Count	600 Count	69 Count
1762269936	92 Count	591 Count	66 Count
1762268135	91 Count	590 Count	66 Count
1762266334	85 Count	585 Count	61 Count
1762264534	72 Count	573 Count	49 Count
1762262733	69 Count	571 Count	47 Count
1762260932	68 Count	571 Count	47 Count
1762259131	67 Count	571 Count	47 Count
1762257340	49 Count	554 Count	30 Count
1762255539	48 Count	554 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)