APRS Track Direct

My position About ☰

reset

EC5CIA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EC5CIA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1786729925	958 Count	569 Count
1786729020	957 Count	569 Count
1786728702	956 Count	569 Count
1786727798	955 Count	569 Count
1786726893	954 Count	569 Count
1786725989	953 Count	569 Count
1786725085	952 Count	569 Count
1786724180	951 Count	569 Count
1786723276	950 Count	569 Count
1786722372	949 Count	569 Count
1786721467	948 Count	569 Count
1786720563	947 Count	569 Count
1786719658	946 Count	569 Count
1786718754	945 Count	569 Count
1786717850	944 Count	569 Count
1786716945	943 Count	569 Count
1786716472	942 Count	569 Count
1786715568	941 Count	569 Count
1786714664	940 Count	569 Count
1786713759	939 Count	569 Count
1786712854	938 Count	568 Count
1786711950	937 Count	568 Count
1786711046	936 Count	567 Count
1786710141	935 Count	566 Count
1786709237	934 Count	565 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)