APRS Track Direct

My position About ☰

reset

PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786838307	357 Count	795 Count
1786836503	356 Count	792 Count
1786834700	355 Count	789 Count
1786832934	350 Count	786 Count
1786831131	349 Count	783 Count
1786829327	348 Count	780 Count
1786827524	347 Count	777 Count
1786825721	346 Count	774 Count
1786823917	345 Count	771 Count
1786822114	344 Count	768 Count
1786820311	343 Count	765 Count
1786818507	342 Count	762 Count
1786816704	341 Count	759 Count
1786814901	340 Count	756 Count
1786813097	339 Count	753 Count
1786811331	334 Count	750 Count
1786809528	333 Count	747 Count
1786807725	332 Count	744 Count
1786805921	331 Count	741 Count
1786804118	330 Count	738 Count
1786802315	329 Count	735 Count
1786800511	328 Count	732 Count
1786798708	327 Count	729 Count
1786796904	326 Count	726 Count
1786795101	325 Count	723 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)