APRS Track Direct

My position About ☰

reset

YD3DCY-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YD3DCY-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1751225563	-41 dBm	0.02 V
1751224937	-42 dBm	0.02 V
1751224311	-41 dBm	0.02 V
1751223685	-42 dBm	0.02 V
1751223059	-41 dBm	0.02 V
1751222432	-41 dBm	0.02 V
1751221806	-41 dBm	0.02 V
1751221180	-40 dBm	0.02 V
1751220554	-42 dBm	0.02 V
1751219928	-40 dBm	0.02 V
1751219238	-42 dBm	0.02 V
1751218612	-44 dBm	0.02 V
1751217986	-41 dBm	0.02 V
1751217360	-42 dBm	0.02 V
1751216733	-43 dBm	0.02 V
1751216108	-42 dBm	0.02 V
1751215482	-41 dBm	0.02 V
1751214856	-42 dBm	0.02 V
1751214230	-42 dBm	0.02 V
1751213604	-43 dBm	0.02 V
1751212978	-41 dBm	0.02 V
1751212353	-42 dBm	0.02 V
1751211727	-41 dBm	0.02 V
1751211101	-41 dBm	0.14 V
1751210474	-40 dBm	0.02 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)