APRS Track Direct

My position About ☰

reset

YD1ION-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YD1ION-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1749329328	-64 dBm	9.86 V
1749329006	-62 dBm	10.05 V
1749328685	-64 dBm	9.86 V
1749328363	-62 dBm	10.05 V
1749328040	-64 dBm	10.05 V
1749327719	-65 dBm	10.05 V
1749326099	-61 dBm	9.86 V
1749325777	-64 dBm	10.05 V
1749325455	-64 dBm	10.03 V
1749325133	-66 dBm	10.03 V
1749324811	-61 dBm	10.11 V
1749324489	-63 dBm	10.05 V
1749324167	-63 dBm	10.05 V
1749323845	-62 dBm	9.86 V
1749323523	-63 dBm	10.05 V
1749323201	-62 dBm	10.03 V
1749322879	-61 dBm	10.05 V
1749322490	-64 dBm	10.05 V
1749322168	-64 dBm	9.86 V
1749321846	-64 dBm	10.05 V
1749321524	-64 dBm	9.86 V
1749321202	-63 dBm	10.09 V
1749320880	-63 dBm	9.86 V
1749320558	-63 dBm	9.86 V
1749320236	-62 dBm	10.03 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)