APRS Track Direct

My position About ☰

reset

IZ2WZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2WZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1758184744	36 Count	626 Count
1758183840	35 Count	612 Count
1758182935	34 Count	593 Count
1758182031	33 Count	575 Count
1758181126	32 Count	561 Count
1758180222	31 Count	546 Count
1758179317	30 Count	531 Count
1758178413	29 Count	515 Count
1758177508	28 Count	506 Count
1758176603	27 Count	494 Count
1758175699	26 Count	481 Count
1758174794	25 Count	453 Count
1758173890	24 Count	438 Count
1758172985	23 Count	425 Count
1758172081	22 Count	408 Count
1758171176	21 Count	386 Count
1758170271	20 Count	365 Count
1758169367	19 Count	348 Count
1758168462	18 Count	328 Count
1758167558	17 Count	307 Count
1758166653	16 Count	277 Count
1758165749	15 Count	268 Count
1758164844	14 Count	248 Count
1758163940	13 Count	233 Count
1758163035	12 Count	211 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)