APRS Track Direct

My position About ☰

reset

SP5UID-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764131702	10 Count	420 Count
1764129900	9 Count	383 Count
1764128099	8 Count	335 Count
1764126298	7 Count	289 Count
1764124496	6 Count	251 Count
1764122695	5 Count	201 Count
1764120894	4 Count	158 Count
1764119092	3 Count	120 Count
1764117291	2 Count	99 Count
1764115490	1 Count	65 Count
1764113688	0 Count	42 Count
1764111887	18 Count	1001 Count
1764110086	17 Count	978 Count
1764108284	16 Count	930 Count
1764106483	15 Count	883 Count
1764104681	14 Count	852 Count
1764102879	13 Count	815 Count
1764101078	12 Count	781 Count
1764099277	11 Count	715 Count
1764097475	10 Count	676 Count
1764095674	9 Count	630 Count
1764093873	8 Count	593 Count
1764092071	7 Count	545 Count
1764090270	6 Count	473 Count
1764088469	5 Count	416 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)