APRS Track Direct

My position About ☰

reset

UB3APB-WY Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UB3APB-WY. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1782488989	255	204	208	243	740
1782488683	255	222	211	243	741
1782488377	255	236	214	243	740
1782488071	255	238	213	243	740
1782487765	255	228	212	243	741
1782487459	255	217	216	243	741
1782487152	254	214	216	243	741
1782486846	253	214	216	243	740
1782486540	254	214	218	243	740
1782486234	254	214	216	243	741
1782485928	254	214	218	244	741
1782485621	254	215	219	243	741
1782485315	254	216	220	243	741
1782485009	254	214	218	244	741
1782484703	253	213	217	244	740
1782484397	254	214	219	244	740
1782484092	254	216	221	245	740
1782483784	254	218	221	245	739
1782483479	255	217	221	245	740
1782483172	255	218	221	246	741
1782482866	255	220	226	246	740
1782482560	255	233	230	246	740
1782482254	255	239	233	246	740
1782481948	255	234	230	245	741
1782481641	255	233	231	245	739

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)