APRS Track Direct

My position About ☰

reset

YC2NFD-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2NFD-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1766283599	-56 dBm	13.54 V
1766250573	-56 dBm	13.54 V
1766249950	-55 dBm	13.54 V
1766249327	-55 dBm	13.47 V
1766248704	-56 dBm	13.49 V
1766248081	-55 dBm	13.49 V
1766247459	-56 dBm	13.54 V
1766246836	-55 dBm	13.54 V
1766246213	-55 dBm	13.49 V
1766245591	-55 dBm	13.54 V
1766244968	-55 dBm	13.54 V
1766244345	-56 dBm	13.49 V
1766243726	-54 dBm	13.49 V
1766243098	-53 dBm	13.49 V
1766242474	-55 dBm	13.54 V
1766241851	-56 dBm	13.49 V
1766241228	-56 dBm	13.49 V
1766240605	-56 dBm	13.54 V
1766239981	-54 dBm	13.49 V
1766239358	-56 dBm	13.49 V
1766238735	-55 dBm	13.49 V
1766238113	-56 dBm	13.49 V
1766237490	-55 dBm	13.49 V
1766236867	-57 dBm	13.49 V
1766236244	-63 dBm	13.49 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)