APRS Track Direct

My position About ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782495755	71 Count	370 Count	60 Count
1782493954	57 Count	308 Count	47 Count
1782492153	44 Count	240 Count	35 Count
1782490369	32 Count	169 Count	28 Count
1782488568	16 Count	79 Count	13 Count
1782486768	247 Count	1056 Count	177 Count
1782484967	210 Count	960 Count	165 Count
1782481371	155 Count	826 Count	144 Count
1782479573	142 Count	730 Count	132 Count
1782477771	128 Count	672 Count	119 Count
1782475969	114 Count	600 Count	106 Count
1782474163	101 Count	523 Count	94 Count
1782472362	90 Count	444 Count	84 Count
1782470561	78 Count	380 Count	73 Count
1782468767	65 Count	328 Count	61 Count
1782465165	37 Count	212 Count	35 Count
1782463359	24 Count	155 Count	23 Count
1782459762	160 Count	1137 Count	144 Count
1782457957	147 Count	993 Count	132 Count
1782456161	132 Count	886 Count	118 Count
1782454356	121 Count	807 Count	108 Count
1782450754	94 Count	625 Count	83 Count
1782448972	80 Count	499 Count	70 Count
1782447165	60 Count	387 Count	57 Count
1782445365	42 Count	277 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)