APRS Track Direct

My position About ☰

reset

VK5RPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK5RPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Vin*	Rx1h*	Dig1h*	Eff1h*	Temp*
1790660902	14.7 Volt	2 Pkt	2 Pkt	100 Pcnt	37.5 C
1790659100	14.7 Volt	2 Pkt	2 Pkt	93 Pcnt	39.5 C
1790657299	14.7 Volt	2 Pkt	2 Pkt	93 Pcnt	39 C
1790655497	14.7 Volt	2 Pkt	2 Pkt	93 Pcnt	38.5 C
1790653695	14.7 Volt	2 Pkt	2 Pkt	93 Pcnt	37 C
1790651893	14.7 Volt	3 Pkt	2 Pkt	97 Pcnt	36.5 C
1790650092	14.7 Volt	3 Pkt	2 Pkt	93 Pcnt	34.5 C
1790648290	14.7 Volt	2 Pkt	2 Pkt	96 Pcnt	32.5 C
1790646488	14.7 Volt	2 Pkt	2 Pkt	100 Pcnt	30.5 C
1790580743	13.05 Volt	3 Pkt	2 Pkt	88 Pcnt	32.5 C
1790578942	13.43 Volt	3 Pkt	2 Pkt	87 Pcnt	34 C
1790577140	14.63 Volt	2 Pkt	2 Pkt	100 Pcnt	33.5 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 1, 0

Dig1h: 0, 1, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -62

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)