APRS Track Direct

My position About ☰

reset

SWANMT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SWANMT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732307796	143	82	70	41	48
1732306593	143	37	70	41	48
1732304182	148	33	70	41	48
1732303577	142	30	70	41	48
1732301153	145	35	73	41	48
1732299941	138	33	74	41	48
1732299334	140	31	72	41	48
1732298731	140	45	76	41	48
1732298123	140	31	73	41	48
1732297521	140	40	74	61	49
1732296918	138	29	74	41	48
1732296317	137	36	74	64	49
1732295710	139	29	74	41	48
1732295105	135	30	76	41	48
1732294500	132	37	94	41	48
1732293899	131	33	74	41	48
1732293295	129	29	75	41	48
1732292692	130	84	76	41	48
1732292084	129	38	75	41	48
1732291482	129	30	101	41	48
1732290276	128	59	74	41	48
1732289670	127	30	76	41	48
1732289069	126	36	76	40	74
1732288463	126	44	75	41	48
1732287859	126	30	75	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)