APRS Track Direct

My position About ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782511700	99 Count	539 Count	37 Count
1782510796	97 Count	526 Count	36 Count
1782509892	95 Count	518 Count	35 Count
1782508987	93 Count	512 Count	34 Count
1782508181	91 Count	505 Count	33 Count
1782507277	90 Count	498 Count	33 Count
1782506373	88 Count	491 Count	32 Count
1782505469	86 Count	483 Count	31 Count
1782504565	84 Count	476 Count	30 Count
1782503661	81 Count	467 Count	28 Count
1782502757	79 Count	459 Count	27 Count
1782501853	77 Count	452 Count	26 Count
1782500949	75 Count	446 Count	25 Count
1782500045	73 Count	430 Count	24 Count
1782499140	71 Count	422 Count	23 Count
1782498236	69 Count	413 Count	22 Count
1782497332	67 Count	406 Count	21 Count
1782496427	65 Count	399 Count	20 Count
1782495523	63 Count	392 Count	19 Count
1782494619	61 Count	385 Count	18 Count
1782493715	60 Count	377 Count	18 Count
1782492811	59 Count	370 Count	18 Count
1782491907	58 Count	357 Count	18 Count
1782491003	57 Count	351 Count	18 Count
1782490099	56 Count	338 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)