APRS Track Direct

My position About ☰

reset

SQ2WSZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1763223171	118 Count	343 Count	63 Count
1763222624	117 Count	340 Count	63 Count
1763220823	115 Count	332 Count	62 Count
1763217222	111 Count	316 Count	60 Count
1763215421	109 Count	307 Count	59 Count
1763213620	107 Count	300 Count	58 Count
1763211827	105 Count	291 Count	57 Count
1763210026	103 Count	281 Count	56 Count
1763208226	101 Count	271 Count	55 Count
1763206425	99 Count	262 Count	54 Count
1763204624	97 Count	255 Count	53 Count
1763202824	95 Count	236 Count	52 Count
1763201023	93 Count	217 Count	51 Count
1763199222	91 Count	208 Count	50 Count
1763197422	89 Count	199 Count	49 Count
1763195621	87 Count	189 Count	48 Count
1763193820	85 Count	181 Count	47 Count
1763192020	84 Count	181 Count	47 Count
1763191867	83 Count	181 Count	47 Count
1763185199	78 Count	167 Count	45 Count
1763183398	76 Count	159 Count	44 Count
1763181597	74 Count	151 Count	43 Count
1763179797	72 Count	142 Count	42 Count
1763177996	70 Count	134 Count	41 Count
1763176195	69 Count	129 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)